MICROMETER ADAPTER

 The need for faster makereadies comes the need for tighter height tolerances on rule and punches. Measuring rule and punch height has always been a difficult task and is rarely accurate or repeatable.

Bar-Plate's new Micrometer Adapter makes that difficult task easy. Just slip in on the barrels of a standard 1" micrometer and start measuring. Precise, accurate and repeatable measurements are a sure thing. Just lay the strip of rule across the flat of the adapter; it enables perfect alignment of the rule and the barrels of the micrometer to the base and cutting edge of the rule.The adapter can be used on full-length strips and coils.The adapter can easily slide along the length of the rule allowing for multiple measurements.

 

The V-Groove in the center of the adapter is designed to hold the punches perpendicular to the face of the barrels.The punch can be rotated in the attachment to enable multiple easurements of the edge. This must-have tool is designed for rule and punches 1” high or less. You can eliminate the use of the wrong height punch or rule by using this simple adapter. If you’re footprinting your press, this is the only tool that can ensure that you have the precise height rule necessary to build and use the footprint die.

 

Copyright © 2006 by Bar-Plate. All rights reserved.